“Work” is the stock you have and part you are creating. Workholding is a critical part of the machining process. If your part is not held properly, it can cause damage to both the part and the tool/machine. This can be due to intense vibrations or the part flying out of the vise. If the part is not held well, it can also blow tolerances, i.e. not being held parallel.
...
The ones that can be used for round parts must be used thoughtfully. They do not hold parts concentric. It is best to use them for earlier operations, and then not used when the part it flipped over. If machining an outer circle, the outer edges will not line up nicely. If machining a top face, it will not be parallel to the bottom face.
...
Soft jaws are jaws that are usually made yourself out of plastic or aluminum. They are shaped to match interesting contours on a part that are not easily held by workholding methods in the shop or easily sourceable.
...
Round Parts in a Mill
Although round parts are usually seen as a lathe item, there are many circumstances in which they need to be put in or made entirely on a mill. There are a few ways to hold onto round parts in a mill, including these from the previous section:
https://nerdocs.atlassian.net/wiki/spaces/NER/pages/166002984/Mill+Workholding#Mitee-Bites https://nerdocs.atlassian.net/wiki/spaces/NER/pages/166002984/Mill+Workholding#Soft-Jaws
Collet Blocks
Collets are round sleeves with slits in them, that tighten around a circular part as the nut on the back of them is tightened. 5C collets are a specific style of collet that is extremely common in both work and tool holding. They are one of the best ways to hold parts concentrically.
...
These collets can be purchased in a wide array of standard fractional sizes, and are typically in stock in any standard machine shop. They have a very limited clamping range, so don’t try to put stock or parts in a 5C collet that is more than a few thou out of the nominal size. Even if parts are larger/smaller than that and they technically fit, the nature of the clamping within the collet means that the part may not be concentric if too far away from nominal size.
Collet blocks are a square or hexagonal block the collet gets inserted to and tightened against. These are blocks that are ground to tight tolerance and can be tightened in a vise for the purposes of workholding.
...
Table-Mounted Chuck
A way to hold larger round parts in a mill is a table mounted chuck. It is the same setup as a 3-jaw chuck on a lathe, except has the ability to be bolted down to the table in a mill. The jaws of this type of chuck can be flipped around, as to grab the part either internally or externally.
...
V-Blocks
V-blocks sit inside the vise and get clamped along with the work. They are ground and can hold parts very concentric. There are a few different sizes of v-blocks depending on part size. You always want to make sure the part is sitting on the flats of the v-blocks, and not so large that they only touch the outer edges. Only one v-block is needed, as long as the third point of contact is another well-defined surface.
...
Accessories
Parallels
Parallels are pairs of ground metal used to elevate the work in a vise.
...