...
Schematic Page Setup
Schematic Templates
{}
Title Block Parameters
{}All schematics in Altium will use a base template. Our vault has been configured such that all projects will default to the NER template, but if needed, the template can be selected from properties.
...
When a schematic sheet is open, the properties panel will default to “Document Options” if nothing is selected. Within properties, the “Page Options” section allows for selection of templates.
Currently, NER has a letter and tabloid size template. We recommend starting with tabloid, and shrinking to letter if space allows once the schematic is done.
Title Block Parameters
By default, the title block will be entirely default. Title block text is updated via parameters in two locations, the documents and the project. Project parameters apply to all sheets and include the Project Name, Revision, and WBS. Document parameters are local to each sheet, allowing each sheet to have unique Sheet Name, Drawer, and Approver.
Similar to the above screenshot, document parameters are found by opening “Document Options” and switching to the “Parameters” tab.
...
There are a lot of “system required” parameters that we unfortunately can’t delete from the template. The parameters you should edit are called “DrawnBy”, “ApprovedBy”, and “Title”
Project parameters can be found by opening Project Options and navigating to the “Parameters” tab. This can be found at the bottom of the “Project” menu, or by right clicking in blank space of a schematic sheet.
...
In both menus, simply update the “Value” of the appropriate parameters and the title block will update automatically!
Basic Components and Wires
...
Open the panel via the panels button (or the components shortcut in the schematics toolbar!)
If you see this just hit the blue “Use Existing Components”
Select component type via the dropdown menu at the top of the panel
Filter results (opened via the button in the top left of the panel)
Just Click + Drag the component in or Right-click and select “Place”
Adjust component position as needed (click and drag)!
...