...
rinse part and take it out
How to Unclog the Nozzle
disconnect abrasive tube from nozzle head and from hopper
make sure garnet is dry still
blow out the bottom of the hopper with an air hose to make sure its dry and unclogged
reinstall hopper to machine
blow air through the abrasive tube from the hopper side to the nozzle side to get any water out
pull lemon down and off
use allen key to loosen thumb screw and wiggle nozzle out
run a test cut to clear out head of waterjet. make sure machine head is positioned between two slats of the bed
reinstall nozzle upside down in the head of the machine. tighten thumb screw
run a test cut to clear out nozzle. make sure the flow appears uniform
reinstall nozzle correctly in the machine
run a final test