Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

For drilling holes with a relatively large depth (over 0.75” deep) use the deep drilling full retract option. You can run drilling feeds and speeds with whatever HSM works defaults to but drill sizes over 3/8” probably should be run at like 60% feed rate on the dial when you’re doing it IRL.

Always include some stock to leave on top of a part when using an adaptive clear so you can follow up with a face operation. HSM works adaptive clear ops sometimes leave behind little ridges about 10 thou thick in certain areas which can either be filed down or taken off with a face op.