...
The starting point that you selected will also be the zero/origin point that you set in the waterjet. I normally will delete the two long green lines (start and end points) in the above screenshot to make them a bit shorter and set the starting point to a convenient location to reference on the stock in the waterjet.
Click save. This will create a .omx file save in the same folder where your .dxf is saved. Put this .omx file on a USB drive and bring to the waterjet.
Cut on the Machine
| Warning |
|---|
if you ever see water coming out of the garnet tube on the left side near the hopper of garnet stop the machine right away |
Message Abby Speckhals in slack to get trained on the waterjet in-person. The steps below can serve as a refresher for people who are already trained.
Turn on the machine with the switch on the right side.
...