...
Below is a download of our standard settings file. We highly recommend utilizing this to automatically setup This automatically sets up your local client settings, such as default templates, color schemes, etc.
This file is also available directly in the vault at: X
XXXX
Directions for use are covered in https://nerdocs.atlassian.net/wiki/spaces/NER/pages/3932597/Altium+Designer#Install-%26-Setup.
The following expand details notes on what we configured in this download.
...
Deprecated. We now embed 3D models directly into footprints.
Saving Items
Projects, components, symbols, and everything else in Altium are all managed in the version control system. Anytime you save to server you will be prompted to enter a commit comment.
You must add a note briefly detailing changes you made on all commits!
Components
Requirements for component files. See https://nerdocs.atlassian.net/wiki/spaces/NER/pages/118718470/Vault+Guidelines#Symbols.1 and https://nerdocs.atlassian.net/wiki/spaces/NER/pages/118718470/Vault+Guidelines#Footprints.1 for the symbols and footprints you embed!
...
Layer Type | Top / Bottom Layer Numbers | Contents |
|---|---|---|
Assembly | 13 / 14 | 3D Model |
Component Outline | 15 / 16 | Outline of physical bounds of package, excluding legs |
Component Center | 17 / 18 | Crosshair at center of component |
Courtyard | 19 / 20 | Clearance required around component / collision box |
Dimensions (OPTIONAL) | 21 / 22 | Additional details component (board edge, insertion direction & clearance, etc) |
...
Solder mask relief must be set to “Rule.” Exceptions should only be made if a component datasheet requests exact values.
Plated Through Holes
Annular ring (the difference in radius between pad radius and hole radius) should be 12 mils / 0.3 mm. Fabricators specify a smaller size which we can use, but we recommend this size for ease of hand solderability.
This means you should take hole size (diameter) and add 0.6mm. See https://www.worthingtonassembly.com/plated-thru-hole-size for more.
Given a pin diameter, the hole size should be determined by adding 0.2mm.
Mounting & GND Pads
If a component requires additional pads that are not regular electrical connections, they must be defined as “GND” or as “MNT” dependent on purpose of the pad. They may be MNT1, MNT2, etc to keep unique identifiers.
...