Categories on the naming sheet:
Master Assemblies -100
System Assemblies - 200
sub assemblies for systems eg. batt box, transmission, knuckle, etc
handling 200H
ergo 200E
structural 200S
Powertrain 200P
Part Files -300
Any item that requires fabrication beyond the item, if cots are modified, tubes bent, parts otherwise edited
Handling 300H
Ergo 300E
Structural 300S
Powertrain 300P
LV 300L
COTS components- 400
Cots Assembly - 400A
Cots part (and multibody) - 400P
Hardware- 500
bolts and fasteners- 501
nuts- 502
clamps- 503
Naming:
Names are to be derived using closest physical description of the item, (then if applicable for distinguishing: size of item, color of item, use of item)
Rev changes:
Rev changes should happen on the parts themselves not car after any change has been made following a cleared for manufacturing part, i.e. if a part has been reviewed, and put into production but an issue was found, a rev B would need to be created.
Parts should be renamed after a rev change, and the drawing for it should follow suit, but the rev A file should be archived as a PDF.
rev changes have to go through the same process as parts to get approved into drawings
Naming Example:
so for a part in the harness assembly on 22 after we found an issue requiring a rework at comp:
300E_ClothToBoltHarnessTabLarge_revB_22
3D Representations of Electrical Parts